3 kg Coating - Laminating System - Epoxy Resin | HP-E30TLS
3 kg Coating, Laminating Resin, Medium Viscous | Epoxy Resin HP-E30TLS
The Epoxy-System HP-E30TLS is an unfilled two-component combination of resin and hardener with medium working time (pot life). It is versatile for surface coating and laminating.Delivery in a sealed pouch.
Features & Benefits:
- Good wet-out of reinforcement fibres
- Very good mechanical and chemical properties
- Universally suitable for pre-sealing or / and laminating of fibre reinforced surface coating
- Direct working on PU- or PS/EPS foam is possible- suitable for indoor use (fish ponds, pools, tanks,…)
- No odour pollution from solvents!
Using for tough, high quality, fibre reinforced coatings in following
- Outdoor AND INDOOR swimming pools, water tanks, fish and aquaculture ponds
- Roofs and rooftops
- Balcony sealing
- Agricultural and industrial coantings
For best results, we recommend a finish with a suitable epoxy-topcoat.
Technical Data Epoxy System E30TLS
- Colouring: Slightly yellow / clear
- Mixing Ratio (by weight): 100 parts resin : 60 parts hardener
- Mixed Viscosity: low viscous
- Working Time (pot life): 30 minutes (100g at 20°C)
- Working temperature (optimum): 20 - 25 °C
- Working temperature (minimum, not below): 15 °C
Download:
Technical Data (PDF)
Working Notes Epoxy Resins
Below you will find processing information for epoxy resins, safety notes and also a decision guide for helping choosing the correct epoxy system.Download:
Working Notes for Epoxy Resins (PDF)
Hazard Statements
Resin:
Warning
H315 Causes skin irritation.
H317 May cause an allergic skin reaction.
H319 Causes serious eye irritation.
H411 Toxic to aquatic life with long lasting effects.
Hardener:
Danger
H302+H312 Harmful if swallowed or in contact with skin.
H314 Causes severe skin burns and eye damage.
H317 May cause an allergic skin reaction.
H412 Harmful to aquatic life with long lasting effects.
